Shanghai Clirik Machinery Co.,Ltd

Start up the machine

1) Turn on main switch

2) Stair air compressor, adjust air pressure of oil-water filter to 0.6-0.7Pa

3) Turn on bag filter pulse controller, adjust the pulse frequency to one spray every 4-5 seconds, adjust pulse width to 0.5-0.8 seconds (pulse controller was set before delivery).

4) Switch on bucket elevator

5) Start up crusher

6) Feed materials to the crusher till enough crushed materials are sent to the hopper, and then start the classifier. 

7) Switch on VVVF/VFD (Variable Voltage Variable Frequency Inverter). Adjust the rotation speed of the classifier. (The rotation speed is subject to the finished fineness required by customers. Usually, 100r.m.p similar corresponds to 100 meshes, please see the following adjusting method of VVVF/VFD).

8) Start up high pressure blower, switch air controller to maximum.

9) Start the main unit after the blower runs normally.

10) Start vibrating feeder, adjust the current of main unit to normal operating amperage( refer to the remarks attached).

11) After preparation of packaging, start discharging valve and screw conveyor for the finished product.

12) All operations complete.

 

 

Switch off the machine:

1) Stop crusher

2) Stop bucket elevator

3) Stop vibrating feeder

4) Stop the main unit when the valve of current is lower than the specified value ( refer to 7-2)

5) Stop the high pressure blower

6) Stop the classifier when the high pressure blower stopped completely

7) Stop the discharging valve and screw conveyor when powder collector and bag filter discharged fully

8) Stop the air compressor

9) Stop the pulse controller

10) Shut down the power