Raymond Mill Operation Process
Before the
Raymond mill starts, it is necessary to check whether all the inspection doors are closed tightly. Check whether the jaw gap of the crusher meets the feed size and adjust the speed of the analyzer to reach the approximate product size. Finally, press in order to boot.
1. Start the bucket elevator; 2. Start the jaw crusher; 3. Start the analyzer after the material is stored in the silo; 4. Start the blower (empty load start, then load after normal operation); The Raymond Mill host starts the electromagnetic vibrating feeder immediately after starting the host. At this point, Raymond grinding work is the beginning.
The operation sequence of Raymond mill is as follows: start: hoist → crusher → analysis machine → fan → main machine → feeder. When the Raymond mill is stopped, the machines should be shut down in the following order:
1. Close the feeder to stop feeding;
2. Stop the host after about one minute;
3. Stop the blower after blowing off the residual powder;
4. Finally shut down the analyzer.
The order of Raymond mill shutdown is: feeder → main unit → blower → analyzer. Note: After the hoist transports the material to the silo for a certain amount, the crusher is stopped first and then the lift is stopped. This should be changed by the stock amount.
Raymond mill is not allowed to refuel at any time during normal work. To ensure safe production, abnormal noise occurs in any part of the
Raymond mill, or if the load suddenly increases, stop it immediately and remove the fault to avoid major accidents. When you continue to turn on the machine, you must take out the remaining material in the mill. Otherwise, the current will be too large when starting up, which will affect the startup.
上一篇：Processing Manganese Ore, Clirik CLUM Vertical Roller Mill is the Best
下一篇：How to Extends the Service Life of the Raymond Mill?
